Controlled drying device samples of UCS-4

.

The UCS-4 drying control device is designed to remove moisture from open sludge pores and is used to determine the open porosity of rock samples.

The drying of the samples is carried out in special containers, which are installed in the drying chamber with the support of the set temperature of heating, by cyclic switching on / off the heater with a thermocouple and control unit.

The temperature of the sludge during the drying process is controlled in each drying chamber by a sensor that contacts the surface of the particles. At the end of drying, it becomes higher than the steam temperature. The drying time of each sample is indicated by the LED indicators that are installed on the control panel front panel and are accompanied by an audible alarm.

.

Technical characteristics the device controlled drying samples of UCS-4

Number of samples drying simultaneously, pcs.	4
The volume of the sample being examined, see 3 , not more	10
Sample drying time, min., Not more	15
Number of light indication channels for drying, pcs.	4
Time to set the operating mode, min.	10
Drying temperature, ° С	75 ± 3 or 105 ± 5
Supply voltage, V	220
Power consumption, W, no more	600
Overall dimensions, mm	235 x 230 x 275
Weight kg	7,5

.

Case for drying Alumina-1

.

The drying vessel ШС-1 is intended for drying slurry, granular sorbents and other loose materials.

Support for the set temperature is created by a thermostat, which provides cyclic switching-off of the electric heater of the drying chamber.

The temperature control is carried out using a thermometer that is lowered into the drying chamber.

.

Technical characteristics cabinets drying shaft-1

Volume of drying chamber, dm 3	12
Tray volume, dm 3	1
Temperature in the drying chamber, after warming up, ° C	105 ± 5
Supply voltage, V	220
Power consumption, W, no more	400
Overall dimensions (length x width x height), mm	410 x 255 x 310
Weight kg	6,5

Next section: Porosity analyzer and density APP-1