Sensor moves drill pump DKN

.

DSC sensor is designed to determine the performance of drilling pumps.

The principle of operation is based on the operation of the primary sensor transducer when approaching its working surface of a metal object.

The sensor consists of a magnetic-induction converter of approximation and a module for normalization. The DNC sensor is installed in the zone of the stroke of the flywheel of the drill pump. The mounting bracket allows you to adjust the position of the sensor in the horizontal and vertical planes. The LEDs of the normalization module serve to indicate the coupling of the sensor when the metal object is approached.

The metal parts of the sensor are made of stainless steel. The body of the normalization module is made of impact-resistant plastics.

The normalization module is used in two versions:

• At the output, a transistor key (open collector) with a 120 ohm resistor is sequentially turned on. The metal object is close - the key is closed.
• with an output signal of 4-20 mA. Output signal proportional to the frequency of operation of the sensor. The output current range corresponds to a frequency of 0-100 Hz. Connection scheme is three-wire.

.

Technical characteristics gauge DKN

Modification	Exit the key	Output 4-20 mA
Measuring range, r / min	0…350 (0…200)	0…100
Supply voltage, V	+12..+24	+12..+24
High-voltage	Current <50mA	Rn
Maximum operating distance (steel), mm	10	10
Operating temperature range, ° С	-40…+65	-40…+65
Weight (with mounting bracket) not more than, kg	3.5	3.5
Consumption current is not more than mA	40	40

.

Next section: Sensor pressure drill bit solution